help I have two SATA III SSD's (240GB each) and One HDD (1TB, also SATA III). I'm trying to set up a RAID 1 or 5 configuration with them, but
the HDD doesn't show in the Rapid Storage Technology app to allow me to select it as one of the drives that I want included in the array.
The motherboard has the Z68 Express Chipset, PCI Express 3.0, and two SATA III controllers (JMicron's JMB36X and Marvell's 91XX
SATA 6G).
Disk1 is an SSD and has Windows 7 PRO on it; The 2nd SSD (Disk2), is currently blank, and the 3rd disk, (Disk0) is the HDD with 4
partitions, 250GB's each and has system backups on one partition, music, photos, videos on another, etc. (disk numbers are as shown in Disk Management).
I have installed the latest drivers for everything, and the Rapid Storage Technology app is installed and ready to configure RAID, (with
the exception of the HDD not showing), I'm currently running RAID mode in BIOS, but haven't configured any arrays.
The two SSD's are connected to the JMicron controller on ports 1,2, and the HDD to the Marvell controller as disk 0, but that shouldn't
make a difference, since both controllers as well as all the disks are SATA III, right?
Why doesn't the HDD show?...it shows on Disk Management and Windows Explorer, and it works just fine!...I want the HDD included in RAID for
its storage capacity and the SSD's for performance, so I've got to figure it out.
Any help will be greatly appreciated in advance.
Thanks!