Hello,
Im installing an Intel RAID on my MB DH57JG, using the RAID RST v.11.0.0.1032.
Im installing 3 HDD with RAID level 5 in order get performance and safety.
All is fine, I tried hot removal of HDD and all is OK.
My question is: if system is suddendly powered OFF (power failure or switch OFF without OS system shut down)
sometimes at next power-on the Array is marked as REBUILDING and Windows OS that is there is NOT
able to complete the boot, due to some sectors that need rebuild... and rebuild need OS running (if i well understand).
Is there any hint about using RAID protection on system disk and avoid this?
As solution I was thinking is to install another (small) disk just for the OS.
This should be working, but unfortunately this disk will be not "protected"
and it will be the "single point failure" that I would like to avoid using RAID.
Thanks for the attention and any suggestion is welcome.