Ok, I'm freaking out a bit, my master disk recently took a dump on me, so I'm running off of m recover drive. I bought a new hard drive & popped it in, but it's not showing up as new hardware, nor is there even an option to rebuild to a new disk! I'm not sure if there's anything special I have to do to the new hard drive I put in, haven't had to do any of this myself in probably 10 plus years.
In status it just says:
Array 0000
Volume_0000: Degraded
Update mode: Continuous
Details: A data recovery operation could not be completed due to a problem reported on the master disk. Fix any problems reported on the array disks to resume the operation, or rebuild the volume to a new disk.
Master disk on port Unknown: Missing
In Manage Disk is says similar stuff:
Port: Unknown
Port location: Unknown
Status: Missing
Usage: Master disk
Size: 0 MB
then it gives the serial number, and the rest is blank from there....
http://imageshack.com/a/img901/6825/9OZlq7.jpg
http://imageshack.com/a/img912/474/hozMbF.jpg
http://imageshack.com/a/img909/8505/05MItj.jpg
http://imageshack.com/a/img911/1092/1nR8T2.jpg
Message was edited by: Ben Conradi